STYLE SRX-RING JOINT GASKETS
Junio 240SRX-Ring Joint Gasket is the same in design to the RX Ring . To distinguish from Junio 240RX-Ring Type Joints the suffix “s” is used to indicate the additional pressure passage hold in the ring cross section. This is to indicate the additional requirement to prevent pressure lock when connections are made up underwater.
Tolerances: (mm)
#Tolerance on these dimensions is +0,-0.015” (+0,-0.4mm)
*Tolerance on these dimensions is +0.02”,-0 (+0.5mm,-0)
A* Width of Ring _____+0.20,-0.00
C Width of flat _______+0.15,-0.00
D Height of Cham ____+0,-0.8
H** Height of ring ____+0.20,-0.00
OD Od of Ring _______+0.5,-0.00
R1 Radius in ring______±0.05
Angle of 23° _________±0 deg 30 min
…………………………………………………………………………………………………………….
Related Products
