STYLE RX-RING JOINT GASKETS
Style RX is a pressure-energized adaptation of the standard Style R gasket. The RX is designed to fit the same groove design as a standard Style R, making the joints interchangeable. The modified design uses a pressure-energized effect that improves the efficiency of the seal as the internal pressure of the system increases.
Tolerances: (mm)
Width of Ring __________ +0.20,-0.00
Height of Ring __________ +0.20,-0.00
(A plus tolerance of 0.20 mm for width and height is permitted, provided the variation in width or height does not exceed 0.10 mm throughout its entire circumference)
OD of Ring _____________ ±0.51,-0.00
Angle of 23°____________ ±0.5°
Note: Only Rings RX82 through RX91 have a pressure passage hole through the cross section. Center line of hole is located on the mid-point of the width flat.
Hole diameter shall be as follows:
RX82 through RX85_______ 1.52
RX86 and RX87__________ 2.29
Rings RX88 through RX91__ 3.05
Прокладка типа JUNIOSEAL RTJ-RX модификация прокладки типа RTJ-R, имеющая более высокие уплотняющие свойства, благодаря тому, что внутреннее давление среды увеличивает контактные напряжения. Прокладки JUNIOSEAL RTJ-RX могут изготавливаться из различных материалов; при специальном исполнении с гальваническим покрытием.
